Some people call these unsafe, silly, great, smart and the list could go on. I call them genius :) My husband has been concerned lately as our daughter just started standing up in her crib. While we lowered her mattress she can still grab the top of her crib although not pull herself up. This little act leads to often bumping her head.
I went online last night in search of a solution. I found Wonder Bumpers. These are great however they are only made for cribs that have slats that are all the same size. Then I realized, hey, I can do this on my own! So I googled DIY wonder bumpers and sure enough. While all had great ideas I combined a few ideas and did it my way!
This is how the day started!
Baby A didn't know what to think! She thought we were done with Home Depot when we finished our home renovations!
Here's what you need:
Pipe insulation (I used 1" with a 1/2" hole) also you must measure all your slats to see how much you need to purchase.
Fabric (again you have to measure, I needed approx. 12 yards) I was liberal
Ribbon Your choice (I would say 4 spools)
Scissors
Time
Patience ;)
I measured and cut the pipe insulators to match my measurements. I then cut the fabric into strips in which could wrap around the pipe insulator. Then I took of the strip that was covering the adhesive on the insulator and stuck the fabric to it. I then wrapped the fabric around repeated. It slid right onto the slat on the crib and I secured it with a ribbon bow up top!
I have to admit that I am pretty happy with the way they turned out! Looking forward to finishing the whole thing!
I only had enough time today to do the front of the crib. I am hoping this will be ok as it's usually this side which she wants to climb :)
Happy Crafting,
XOXO
S